Stroller Operation; Unfolding And Folding - B.O.B RAMBLER Guia Del Usuario

BOB Gear
Rear Wheel Removal
1� Unlock Parking Brake
Prior to removing the rear wheels,
position the parking brake in the
unlocked position.
2� Remove Wheel
Raise the wheel a few inches off
the ground, pull the release lever,
and pull the wheel out of the rear
wheel attachment bracket.
Front Wheel Installation
1� Remove Through Axle and Hex
Wrench From Storage Bag
Remove nut from through axle.
Nut Through Hex
Axle Wrench
2� Rotate Front Fork Into Jog
Mode
Rotate the front fork until it locks
into jog mode. See page 8.
6
3� Insert Front Wheel
When facing the front of the
stroller, insert the wheel between
the fork and align the wheel hub
with the holes in the fork blades.
4� Insert Through Axle
Insert the through axle into the
fork and through the wheel hub,
then install the nut to the opposite
side.
Nut
5� Tighten Through Axle
Hold the nut in place, and use
the hex wrench provided to fully
tighten the through axle. Pull on
wheel to check that it is securely
installed and does not wobble.
Check the front wheel before
each use of the stroller to
ensure it is properly secured�
Failure to secure the front
wheel can cause the wheel to
vibrate, wobble, or become
detached from the stroller�
FALL HAZARD - Wheel can
detach and cause tip over� Pull
on the wheel to assure it is
securely attached�
Front Wheel Removal
1� Rotate Front Fork Into Jog
Mode
Rotate the front fork until it locks
into jog mode. See page 8.
2� Remove Through Axle
Hold the nut in place and use the
hex wrench to loosen the through
axle. Then remove the through
axle from the front wheel and
fork.
3� Remove Front Wheel
Raise the front wheel a few inches
off the ground and tap the top of
the wheel with the palm of your
hand to knock the wheel out of
the front fork.

Stroller Operation

Unfolding and Folding

Unfolding the Stroller
1� Unbuckle the wrist strap
2� Lift Red Frame Release Handle
Keep tires on ground as stroller
swing arm begins to swing open.
RAMBLER User Guide
NOTE: Stroller swing arm will
swing open and snap into an
open and locked position.
3� Open Stroller
Lift handlebar up and back until
stroller snaps into locked and
upright position.
Folding the Stroller
1� Lock Parking Brake
Set parking brake in locked
position.
2� Remove Child From Seat
3� Empty Stroller
Remove contents from low boy
cargo basket.
7