Air Conditioner Ceiling-Floor
3.ACCESORIES
Owner's manual (1)
Installation manual (1) (these manual)
Hook (2)
Hanging arm (2)
Remote controller & its frame
1. Remote controller (1)
2. Frame (1)
3. Mounting screw (ST 2,9x10 C-H) (2)
4. Alkaline dry batteries (AM4) (2)
Cautions on remote controller installation
•
Never throw or beat the controller.
•
Before installation, operate the remote controller
to determine its location in a reception range.
•
Keep the remote controller at least 1mapart from
the nearest TV set or stereo equipment. (It is
necessary to prevent image disturbances or noise
interferences.)
•
Do not install the remote controller in a place
exposed to direct sunlight or close to a heating
source, such as a stove.
•
Note that the positive and negative poles are
right positions when loading batteries.
4. INDOOR UNIT INSTALLATION
Installing Ø10 hanging screw bolts. (4 boltf s)
Please refer to the following figure for the distance
measurement between the screw bolts.
Please install with Ø10 hanging screw bolts.
The handling to the ceiling varies fromthe
constructions, consult the construction personnels
for the specific procedures.
1. The ceiling where the works will be done must
be flat. Consolidate the roof beamfor possible
vibration.
2. Cut off the roof beam.
3. Strengthen the place cut off, and consolidate
the roof beam.
Carry out the pipe and line operation in the ceiling
after finishing the installation of the main body.
While choosing where to start the operation,
determine the direction of the pipes to be drawn
out. Especially in case there is a ceiling, position
the refrigerant pipes, drain pipes, indoor & outdoor
lines to the connection places before hanging up
the machine.
in
3
EN