Making Cuts; Bevel Cut; Adjusting Blade Height; Maintenance - Lackmond BEAST5 Manual De Instrucciones

MAKING BEVEL CUTS
The saw enables you to make beveled cuts from 0 to
45-degrees.
To make a bevel cut:
1. Ensure the saw is un-plugged from the power
source.
2. Loosen the bevel lock (12) .
3. Tilt the saw head to the side until the pointer on the
saw head aligns with the desired bevel as shown on
the bevel indicator.
4. Tighten the bevel lock.
5. The cut line indicator (B) can be used for alignment.

ADJUSTING BLADE HEIGHT

You can adjust the height of the depth of cut to
accommodate materials of varying thickness, up to 2
3/8 inches at 90 degrees.
1. Ensure the saw is un-plugged from the power
source.
2. Loosen the blade height lock wing screw (6).
3. Tilt the saw head forward to increase the blade
height (Note: This will reduce the depth of cut.)
4. Once the saw head is re-positioned, re-tighten the
blade height wing screw.
For your safety, turn off the switch and unplug saw from the power source before performing any
maintenance or cleaning. If the power cord becomes damaged in anyway, have it replaced imme
diately with approved cord by the manufacturer or its agent. When cleaning the saw, do not expose the motor to
direct water. If excessive water is introduced into the motor, electric shock and/or damage to the motor can occur.
Do not service the electric motor's internal components yourself. Contact an authorized service center.
Never use water or any other chemical liquids to clean the electrical parts of the machine.
Use a soft cloth to clean off the water and dust from the machine.
Keep the ventilation slots of the motor clean to prevent overheating.
Periodic maintenance of your tile saw allows for long life and trouble-free operation. The cutting residue that the
saw generates could be considerable. A cleaning, lubrication, and maintenance schedule should be maintained.
As a common sense and preventative maintenance practice after each use, follow these recommended steps:
Clean the entire saw with fresh water after each use.
Inspect the diamond cutting wheel for its overall integrity. Check the rim for wear or damage
and replace cutting wheel if necessary.

MAKING CUTS

MAINTENANCE

11 12
B
FIGURE 12
FIGURE 13
12
6