Control Panel Recognition Programming - hager S771-22X Manual De Instalación

Recognition programming
Control panel recognition
programming
The control panel must be in installation mode for pro-
gramming (see control panel installation manual).
Control panel recognition programming is only
required for Remote Control, System Status
Feedback and Activation on Intrusion applications.
Once recognition programming is complete, it is
exclusive. To teach the external receiver to operate
with a different control device, the initial recognition
programming must be erased as described in the
"Return to factory programming" chapter.
G
B
Perform programming as follows:
Press the
external receiver
programming
key (for less
than 2 sec.).
The programming
LED will light
up temporarily.
If you make a programming error, the programming
LED will flash quickly. You must carry out the program-
ming sequence again from the start.
126
Press and hold
The key external receiver
on the Light page confirms
until the
programming
external receiver
by its
programming
programming
LED lights up.
LED lighting
up for 2 sec.
The