Pre Start Checks; Basic Operation - Evolution TWISTER Manual De Instruccion

SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
ADDITIONAL SAFETY INSTRUCTION
For your own personal protection and for the safety of those
around you, please read and ensure you fully understand
the following safety information. It is the responsibility of
the operator to ensure that he/she fully understands how to
operate this equipment safely. If you are unsure about the
safe and correct use of the 'TWISTER' mixer, consult your
supervisor, distributor or Evolution Power Tools.
Motor (110 or 230V ~ 50/60Hz )
No Load Speed
Coupling Thread
Vibration (m/sec
Usage Time (mins)
Sound Power Level (LWA)
Mix Paddle Max Dia (mm)
Weight (Kg)
Height (Max) - Operation (mm)
Depth (Max) (mm)
Width (Max) (mm)
Unpacking and Checking Content
Your 'TWISTER' is shipped in one box. Remove the tool and all loose parts from
the carton. Place all parts on a secure, stationary work surface and inspect the
machine carefully.
Loose parts included
'TWISTER' Unit
Paddle
Wrench
Operator's Manual
NOTE: Before beginning assembly, check that all parts are included. A complete
parts list (Repair Parts) is in the middle of the manual.
Pre start-up inspection
The following Pre start up inspection must be performed before the start of each
work session or after every four hours of use. If any fault is discovered, the
'TWISTER' must not be used until the fault is rectified.
1. Thoroughly inspect the 'TWISTER' for signs of damage. Make sure that the
mixer paddle is secure before using the machine.
Switch
On/Off Trigger Switch - to start the machine, squeeze the trigger switch. Release
the trigger switch to stop the motor. This machine is equipped with a lock-on pin.
If continuous operation is required, squeeze the trigger and press the pin. To
stop, squeeze and release the trigger switch.
Speed Adjustment
By turning the thumb operated adjustor wheel, the speed may be adjusted
electronically for best mixing performance in a given medium.
How to use the Tool
Effective control of this machine requires two-handed operation for maximum
SPECIFICATIONS
)
2

PRE START CHECKS

BASIC OPERATION

(Min
4
1100 W
) 250 - 750
-1
M14 - 2.0
0.5 - 0.7
30
< 94 dB(A)
120
4.9
863
240
330
Quantity
1
1
1
1