Tabla de contenido
Idiomas disponibles
Idiomas disponibles
assembly (a,b)
· Slide the ends of the connection arms
into the tubes on the board until you
hear each end click firmly into the re-
quired position.
· ! Left and right are indicated onto the
connection arms.
· Then attach the wheel to the foot board
by sliding it along the axis.
attaching the step-up board to the Mutsy
evo. (d)
· If you have a Mutsy Evo, fit the two 2
plastic Evo rings on the attachment
clips first. The Evo attachment rings
are marked "EVO" and "L" or "R".
Open the clips fully and click the at-
tachment ring into the clip.
· Open the clips to attach the Step-up
board. Place the clips around the brak-
ing bar, at the back of the underframe.
The clips will close around the braking
bar when you release them. Check that
the clips are fully properly and that the
Step-up board is attached securely.
attaching the step-up board to the Mutsy
Igo and exo (e,f)
· If you have a Mutsy Igo or Exo, fit the
two 2 plastic Igo/Exo rings on the at-
tachment clips first. These attachment
clips are marked "L" and "R". Open
the clips fully and click the attach-
ment ring into place. Make sure that
the triangle symbol lines up with the
triangle symbol on the clip.
· Open the clips to attach the Step-up
board. Place the clips around the
cross connection bar, at the back of
the underframe. Make sure that you
don't place the Step-up board over
the basket and if necessary undo the
outer press studs on the basket. The
clips will close around the cross con-
nection bar when you release them.
Check that the clips are fully closed
properly and that the Step-up board
is attached securely.
Disassembling the step-up board
· To store the Step-up board compactly,
remove the wheel by pressing the but-
ton and sliding it off the axis. You can
also remove the connection arms to
make it more compact.
Maintenance
· If necessary, spray the moving parts
with Teflon spray (dry lubricant) and
wipe with a soft cloth.
English
7
Tabla de contenido
