Controls & Features - Troy-Bild Storm 1130 Manual Del Operador

Controls and Features
Drive Control
Chute Assembly
Clean Out
Tool
Augers
Snow thrower controls and features are described below and
illustrated in Fig. 4-1.
NOTE: For detailed information on all engine controls, refer to
the separate Tecumseh Engine Operator's Manual.
Shift Lever
The shift lever is located in the right side of the
handle panel and is used to determine ground
speed and direction of travel.
Forward
There are six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest.
Reverse
There are two reverse (R) speeds. One (1) is the
slower and two (2) is the faster.
10
Electric Start Button
Gas Cap
Oil Fill
Skid Shoe
Shift Lever
Chute Directional Control
Auger Control
Heated Grips
Steering Trigger Control
Ignition
Key
Choke
Control
Throttle
Control
Figure 4-1
Choke Control
The choke control is found on the rear of the engine and is
activated by rotating the knob clockwise. Activating the choke
control closes the choke plate on the carburetor and aids in
starting the engine.
Ignition Key
The ignition key is a safety devise. It must be fully inserted in
order for the engine to start. Remove the ignition key when the
snow thrower is not in use.
Note: Do not turn the ignition key in an attempt to start the
engine. Doing so may cause it to break.
Engine Controls
Recoil Starter
Handle
Electric Starter Outlet
Primer
4