Using Instructions - Palram GP 08 24 Manual Del Usuario

EN
READ INSTRUCTIONS CAREFULLY:
Place instructions in a safe place for future reference.
Do not allow anyone who has not read these instructions to assemble, light, adjust or operate the heater.
This product is only suitable for well insulated spaces or occasional use.
1. Cautions
1.1 This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance shall not be made by children without supervision.
1.2 WARNING: In order to avoid overheating, do not cover the heater.
1.3 Children of less than 3 years should be kept away unless continuously supervised.
1.4 Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been
placed or installed in its intended normal operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved.Children aged from 3 years
and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
1.5 CAUTION - some parts of this product can become very hot and cause burns. Particular attention has to be given
where children and vulnerable people are present.
2. Introduction
2.1 Depending on the power cord type this fan heater may be used only in household, warehouses and workshops,
building sites or greenhouses depending. It incorporates a thermostat and a self-resetting thermal cut-out to
control the heating elements. The thermostat feels the air temperature and controls the surrounding temperature.
The fan motor is controlled by thermostat and it keeps on working when the thermostat cuts off the heating
element. The self-resetting thermal cut-out will switch off the heater to ensure the safety when overheating.
2.2 When using the heater for the first time, you may notice a slight emission of smoke. This is quite normal and it
stops after a short time. The heating element is made of stainless steel and was coated with protection oil by
production. The smoke is caused by the left oil when heated.
3. Preperation
Model GP 08 24
Voltage 220-240V~
required power 2400W
current 10-10.91A
Required Fuse 15A
Setting 35/1200/2400W
Self-resetting
70°C
Thermostat
Product meas (mm) 295*262*363
N.W.(KG) 4.5
5. Special safety regulations
5.1 Before use, please check the marking on the power cord. Depending on the power cord type this appliance
may be used in different ambient conditions.
Read and follow all instructions.
3.1 Housing of steel plate and coated by
GP 08 15
heat-resistant powder.
110V~120V~
3.2 Supplied complete with cord and plug.
1500W 4. Description of Control Panel
12.5-13.64A
15A
40/1500W
75°C
295*262*363 4.1 Left Knob: selector with heat setting
4.2 Right Knob: Thermostat dial
4.7
Type You can use the appliance in
household, warehouses and workshops, building sites
H07RN-F
or greenhouses
H05RN-F household, warehouses and workshops or greenhouses building sites
H05RR-F household, warehouses and workshops
5.2 When using electrical appliance basic precautions should always be followed including below:
5.2.1 The fan heater is not suitable for use outdoors in damp weather, in bathrooms or in other wet or
damp environments.
5.2.2 Please note that the fan heater can become very hot and should, therefore, be placed at a safe
distance from flammable objects such as furniture, curtains and similar.
5.2.3
Do not cover the fan heater.
5.2.4 The fan heater must not be located immediately below a socket outlet.
5.2.5 Do not connect the fan heater using an on/off timer or other equipment which can automatically
switch the device on.
5.2.6 The fan heater must not be placed in rooms where flammable liquids or gases are used or stored.
5.2.7 If an extension cord is used, it must be as short as possible and always be fully extended.
5.2.8 You must not connect other appliances to the same mains socket as the fan heater.
5.2.9 Do not use this fan heater in the immediate surroundings of a bath, a shower or a swimming pool.
5.2.10 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
5.2.11 Make sure heater is always under surveillance and keep children and animals away from it;
5.2.12 Do not place the appliance on moving vehicles or some where easy to be tipped over.
5.2.13 When you don't use the appliance for a long time, unplug the appliance. Don't leave the heater for
a considerable amount of time when in use. Pull the plug straight out, never remove the plug by
pulling on the cord.
5.2.14 Keep the heater far from curtain or places where the air inlet can easily be blocked.
5.2.15 The power coupler is waterproof when not in use. In order to prevent possible electric shock or
leakage current, never use the appliance with wet hand or operate the appliance when there is
water on the power cord.
5.2.16 Do not dispose of electrical appliances as unsorted municipal waste, use separate collection
facilities. Contact you local government for information regarding the collection systems available.
If electrical appliance are disposed of in landfills or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your health and well-being.
5.2.17 This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
5.2.18 Children should be supervised to ensure that they do not play with the appliance.

6. Using Instructions

6.1 Position the fan heater so that it stands upright on a firm surface and at a safe distance from wet
environments and flammable objects.
6.2 Connect the fan heater to the mains.
6.3 Set the thermostat knob to the MAX and let the heater operate with full power.
6.4 The fan heater will switch on when the heating selector is set to one of the power settings.
6.5 Once the room reaches the required temperature, heating element will stop working but fan also
working .Once the temperature decreased, the heating element will be working. The fan heater now
starts and stops automatically and thus keeps the room temperature constant.
6.6 Before switch off the heater, please turn the thermostat to MIN position and turn the switch to fan
position, let the appliance cool down for two minutes then turn off the heater and pull out the plug.
Do not use in
building sites or greenhouses