Microsoft Surface Hub 55 Manual De Usuario página 10

A. Prepare the hanger bars.
a. 55" Surface Hub: Make sure the hanger bar clamps are closed.
If the clamps are not fully closed, turn the clamp screws clockwise to close them (see images below).
b. 84" Surface Hub: Make sure the hanger bar clamps are open.
If the clamps are not fully open, turn the clamp screws counter-clockwise to open them.
Clamp screw
B. Lift the Surface Hub, using the handhold locations as shown above, and align the top hooks of the hanger bars with the top edge of the wall plate (see image below). Then GENTLY lower the Surface Hub to seat the
hanger bar hooks on the wall plate. Be sure to use ergonomic lifting techniques.
Top Hook
Wall Plate
WARNING:
To reduce the risk of the Surface Hub falling, do not release it until you are sure the hanger bars are properly seated on the wall plate.
• When you release the 55" Surface Hub, the clamp holds the bottom of the Surface Hub away from the wall to make cable connection easier.
Clamp for 55" Surface Hub resting on wall plate
(Surface Hub not shown)
• When you release the 84" Surface Hub, it rests against the wall. Do not lift or pull the Surface Hub away from the wall while it's in this position.
8
Clamp open
Top hook not engaged
Clamp closed
Top hook fully engaged
K