Channel Settings - Clarity AlertMaster AL10 Guia Del Usuario

Channel Settings

The AlertMaster System uses special radio signals to communicate
between the console unit and all its accessories. For the accessories
(Door Announcer, Baby Sound Monitor, Audio Alarm Transmitter and
Motion Sensor) to activate the base unit, they all have to be on the same
"channel." A "DIP switch" is used for channel selection.
Your system and all the accessories have been preset in the factory to a
standard channel setting. Under normal operating conditions, there is
no adjustment necessary.
If your system encounters interference and repeatedly activates itself
for no obvious reason, it may be triggered by a system nearby in your
neighborhood.
If the interference from another AlertMaster Notification System or
other wireless source is present, change channel switch settings on all
components.
1. Unplug AC power and locate DIP switch (a 4-position switch) on the
back of the AlertMaster AL10. Lift rubber cover to access the switch.
2. Open the battery compartment of the doorbell.
3. Change the switch position of each switch on both units using a ball
point pen. All settings need to be identical for the system to work.
4. Change the switch settings on each of your other accessories (Remote
Receiver, Audio Alarm Transmitter, Baby Sound Monitor, etc.) to match
the new channel setting.
5. Replace all covers and return accessories to their proper places. Press
RESET / PAGE button once to reset the unit.
19
Channel Settings
DIP switches on back of doorbell
Use a pen or pencil to
set DIP switches to
match exactly.
MIC
ALL MAIN OFF
BEDSHAKER
PHONE PHONE LINE
AlertMaster AL10 base unit
1 2 3 4
Open rubber cover
and adjust switch.
1 2 3 4
NIGHTLIGHT
SET CLOCK
ON OFF
™
LAMP
POWER CABLE
E
N
G
L
I
S
H
20