Dual Assignment Instructions (Long Button Press) - Axxess AX-FD2-SWC Instrucciones De Instalación

Button assignment legend
1. Volume-Up
2. Volume-Down
3. Seek-Up/Next
4. Seek-Down/Prev
5. Source/Mode
6. Mute
7. Preset-Up
8. Preset-Down
9. Power
* Not applicable if the vehicle is equipped with SYNC
** Not applicable in this application
Note: Not all radios will have all of these commands. Please refer to the manual provided
with the radio, or contact the radio manufacturer for specific commands recognized by that
particular radio.
6
STEERING WHEEL CONTROL SETTINGS
10. Band
11. Play/Enter
12. PTT (Push to Talk) *
13. On-Hook *
14. Off-Hook *
15. Fan-Up **
16. Fan-Down **
17. Temp-Up **
18. Temp-Down **
(CONT)

Dual assignment instructions (long button press)

The AX-FD2-SWC has the capability to assign (2) functions to a single button, except
Volume-Up and Volume-Down. Follow the steps below to program the button(s) to
your liking.
Note: Seek-Up and Seek-Down come pre-programmed as Preset-Up and Preset-Down
for a long button press.
1. Turn on the ignition but do not start the vehicle.
2. Press and hold down the steering wheel control button that you want to assign a long
press function to for about (10) seconds, or until the L.E.D. flashes rapidly. At this point
release the button; the L.E.D. will then go solid.
3. Press and release the Volume-Up button the number of times corresponding to the
new button number selected. Refer to the Dual Assignment Legend. The L.E.D. will
flash rapidly while the Volume-Up button is being pressed, and then go back to a solid
L.E.D. once released. Go to the next step once the Volume-Up button has been pressed
the desired number of times.
Caution: If more than (10) seconds elapses between pressing the Volume-Up button, this
procedure will abort, and the L.E.D. will go out.
4. To store the long press button in memory, press the button that you assigned a long
press button to (the button held down in Step 2). The L.E.D. will now go off indicating
the new information has been stored.
Note: These steps must be repeated for each button you would like to assign a dual purpose
feature to. To reset a button back to its default state, repeat Step 1, and then press the Volume-
Down button. The L.E.D. will go out, and the long press mapping for that button will be erased.
Continued on the next page