Tabla de contenido
Q6.
I configured my print server to automatically receive an IP Address
from a DHCP server, and now I cannot go into the print server's web
utility.
A6.
Press the Reset button at the back of the TE100-P21, hold the button
for 15 seconds, release the button, and enter http://192.168.0.1 in a
web browser to access the web utility feature.
Q7.
I pressed the reset button and held it for 15 seconds. I also typed in
http://192.168.0.1 in a web browser, but I still cannot access my print
server.
A7.
Make sure to change your local IP address to 192.168.0.xxx where
xxx is an available number between 2 to 254. You can also use the
PS-Utility to locate the print server's IP address, or enable UPnP.
If you have any questions regarding the print server, please contact TRENDnet
Technical Support Department.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received.
Including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO
OPERATE THE EQUIPMENT.
Waste electrical and electronic products
must not be disposed of with household
waste. Please recycle where facilities
exist. Check with you Local Authority or
Retailer for recycling advice.
8
Tabla de contenido
