Engine Oil; Troubleshooting - Craftsman 917.377541 Manual Del Propietário

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ENGINE OIL
Drain oil (with engine warm) and replace with
clean engine oil. (See "ENGINE" in the
Maintenance section of this manual).
CYLINDER
o Remove spark plug.
• Pour one ounce (29 ml) d oil through spark
plug hole into cylinder°
o Pull starter handle slowly a few times to
distribute oil.
• Replace with new spark plug.
OTHER
o Do not store gasoline from one season to
another.
° Replace your gasoline can if yourcan starts
to rust. Rust and/or dirt in your gasoline will
cause problems.
If possible, store your unit indoors and cover
it to give protection from dust and dirt.
o
Cover your unit with a suitable protective
cover that does not retain moisture. Do not
use plastic, Plastic cannot breathe which
allows condensation to form and will cause
your unit to rust.
IMPORTANT: Never cover mower while
engine and exhaust areas are still warm.
CAUTION:
Never store the lawn mower
with gasoline in the tank inside a building
where fumes may reach an open flame or
spark. Allow the engine to cool before
storing in any enclosure.
i
i,
iu,,
PROBLEM
Does not start
TROUBLESHOOTING
CHART
i
i,i ,J,u
CAUSE
= Dirty air filter.
o Out of fuel.
• Stale fuel.
o Water in fuel.
° Spark plug wire is
disconnected.
• Bad spark plug.
• Loose blade or broken blade
adapter.
o Control bar in released
position.
° Control bar defective.
,ll,,,
,L
,, J,IL,,,II,
CORRECTION
o Clean/replace air filter°
o Fill fuel tank.
• Drain tank and refill with
fresh clean fuel.
° Drain fuel tank and
carburetor and refill tank
with fresh gasoline,
o Connect wire to plug.
° Replace spark plug.
° "lighten blade bolt or
replace blade adapter.
° Depress control bar to
handle.
= Replace control bar.
16
Tabla de contenido
loading

Tabla de contenido