Idiomas disponibles
Idiomas disponibles
1. Run power cable to installation location. Position the hood in its intended location. Using a pen, mark the position of the
screws (smaller part of the keyhole, see picture below for the 5 keyhole locations). Remove the hood.
Install (4) #8 x 1/2"screws,
leaving a l/s" gap. Do not install the #5 screw yet.
4D0168
2. Attach the wire clamp, insert the power cable in the hood and tighten the wire clamp to secure the cable. Place the hood under
the cabinet and slide it in position. Make sure the adapter/damper
assembly enters the duct opening. Tighten the (4) screws
completely, then add the last screw (screw #5) in the center keyhole. Make sure the damper flap opens freely.
_hb
WARNING: Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance
with all appJicable codes and standards. Before connecting wires, switch power off at service panel
and lock service disconnecting means to prevent power from being switched on accidentally.
1. Connect cable using provided wire connectors.
Connect BLACK to BLACK, WHITE to WHITE and GREEN
or bare wire under GREEN ground screw.
DO NOT FORGETTO
CONNECTTHE
GROUND.
See illustration beside.
1. Reinstall both side panels. DO NOT FORGET TO PLUG
BACK THE MGHT CONNECTORS!
2. Reinstall
bottom panel using 5 screws from Step 3 of
"Prepare The Hood" Section.
CAUTNON:
Remove protective plastic film covering
filters before installing them.
3. Reinstall both filters.
10
