Troubleshooting - VOSS.farming XTREME duo X110 Manual Del Usuario

9. TROUBLESHOOTING

If the fence has no impulse or the voltage is below 3 kV and the red LED on the LED BAR
flashes, then the following must be checked
Cause
The energiser doesn't work.
The LED control light flashes red.
The LED indicator light flashes red and a warning sound
is emitted.
No light on the LED control lamp.
Leakage or short circuit of the fence.
The conductor has unfavourable properties (thin con-
ductor, high resistance)
Poor grounding, grounding rod too short, corrosion,
dry ground
Leakage through vegetation on the fence.
46
Troubleshooting
Disconnect the energiser from the fence and then
switch it on again! If the blue or purple LED is on and
the yellow or green LED on the LED BAR is flashing,
the unit is OK. Otherwise the unit is damaged (con-
tact your dealer)! When using battery and AC adap-
ter, make sure the polarity is correct!
The battery voltage has dropped below 12 V. Repla-
ce the battery with a sufficiently charged battery or
connect the adapter.
The battery voltage has dropped below 11.6 V
- replace the battery with a sufficiently charged
battery or connect the adapter.
Or the fence has been subjected to a sudden load
or the voltage has been reduced, see "1. important
information ", page 28. The cause must be elimi-
nated.
The energiser is either switched off manually or
the battery voltage has fallen below 11.4 V and the
fence has been switched off automatically. The
reason for this is to protect the battery from deep
discharge (destruction of the battery). Replace
the battery with a sufficiently charged battery or
connect the adapter
Never use a conventional cable for the fence
connection. We recommend using a high voltage
cable.
Use a high-quality conductor with low resistance
and a larger cross-section. Ensure a high quality
wiring of the conductors.
Add a rod, add water.
Remove vegetation (mow)!