Esd Precautions; Operating Precautions; System Setup - Hardware; Introduction - Bosch 1400 Serie Guía De Instalación Rápida

1400 Series/4-bay IP Video Storage System
–
–
1.3

ESD Precautions

Electrostatic Discharge (ESD) is generated by two objects with different electrical charges
coming into contact with each other. An electrical discharge is created to neutralize this
difference, which can damage electronic components and printed circuit boards. The
following measures are generally sufficient to neutralize this difference before contact is
made to protect your equipment from ESD:
–
–
–
–
–
–
–
–
1.4

Operating Precautions

Care must be taken to assure that the chassis cover is in place when the system is operating
to assure proper cooling. Out of warranty damage to the system can occur if this practice is
not strictly followed.
Note:
Please handle used batteries carefully. Do not damage the battery in any way. A damaged
battery may release hazardous materials into the environment. Do not discard a used battery
in the garbage or a public landfill. Please comply with the regulations set up by your local
hazardous waste management agency to dispose of your used battery properly.
2

System Setup - Hardware

2.1

Introduction

Scope of delivery:
–
Bosch Sicherheitssysteme GmbH
DVD-ROM Laser:
CAUTION - this system comes without a DVD-ROM drive but if added: To prevent direct
exposure to the laser beam and hazardous radiation exposure, do not open the enclosure
or use the unit in any unconventional way.
Mainboard replaceable soldered-in fuses: Self-resetting PTC (Positive Temperature
Coefficient) fuses on the mainboard must be replaced by trained service technicians
only. The new fuse must be the same or equivalent as the one replaced. Contact
technical support for details and support.
Use a grounded wrist strap designed to prevent static discharge.
Keep all components and printed circuit boards (PCBs) in their antistatic bags until ready
for use.
Touch a grounded metal object before removing the board from the antistatic bag.
Do not let components or PCBs come into contact with your clothing, which may retain a
charge even if you are wearing a wrist strap.
Handle a board by its edges only; do not touch its components, peripheral chips, memory
modules or contacts.
When handling chips or modules, avoid touching their pins.
Put the mainboard and peripherals back into their antistatic bags when not in use.
For grounding purposes, make sure your computer chassis provides excellent
conductivity between the power supply, the case, the mounting fasteners and the
mainboard.
1400 Series – 4-bay system, fully equipped with 4 hard drives
Quick Installation Guide
System Setup - Hardware | en
- | V1 | 2011.03
21