HAMPTON BAY Windward II Manual Del Propietário página 8

Setting the Dip Switches In
the Receiver:
In the transmitter, the dip switches are
accessible from the battery compartment
as shown in Figure A. The dip switches in
the receiver are located on top of the fan
motor assembly as shown in Figure B. The
dip switches are accessible through the top
of the motor assembly. Set the switches in
the same position as the switches in the
transmitter. After the dip switch positions
have been changed and you have assured
that they match the settings in the transmit-
ter, turn the power on and test.
6.
Make sure the dip switches setting in the
transmitter match the receiver.
When two or more fans are located near
each other you may want to have each set
to a different frequency so that operation
of one fan will not interfere with the other.
This can be done by changing the ON/OFF
position of any one or more of a group of 4
dip switches grouped together in the trans-
mitter. The receiver, located on the top of
the fan motor assembly, has a similar set of
dip switches which must also be changed
to match the transmitter settings. Because
the dip switches are small, please use a fine
point instrument to adjust the settings.
Dip Switches
ON ECE
1 2 3 4
Optional
Transmitter
Battery
Compartment
Figure A
Figure B