Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Take out the orifice support, and then use a 6 mm socket
and wrench or 6 mm nut driver to remove the LP orifice at
the end of the supply pipe. Replace with Natural gas orifice.
IMPORTANT: Check that the orifice is properly installed
inside of supply pipe.
7. Reinstall the orifice support and supply pipe and tighten the
nut with a 24 mm wrench.
8. Reinstall the spider guard, access cover, and wind baffle.
8
Change the Sear burner orifices
1.Remove the screw securing the igniter and the 2 searing
side burner screws.
2. Lift the searing side burner out of the grill.
3. Locate the LP gas orifice to the end of the valve.
4. Use 6 mm socket wrench or 6 mm nut driver to remove
the orifice. Replace with the Natural gas orifice.
Tabla de contenido
