Fan Assembly; Wall Control Wiring - Craftmade Bellows IV Guia De Instalacion

6. Fan Assembly.

Secure fan to wall bracket by inserting the
tube into the wall bracket, then tighten the
four set screws on the wall bracket with the
Allen wrench provided in one of the hardware
packs.
Slide canopy to wall bracket and tighten set
screws on canopy, with the Allen wrench
provided in one of the hardware packs.

7. Wall Control Wiring.

IN ORDER TO WIRE WALL CONTROL, remove
existing wall switch. Wire the WALL CONTROL
with wire connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
WARNING: CONNECT WIRES IN THE FOLLOWING
ORDER:
Connect GREEN ground wire to ground from
house or directly to one of the screws from the
outlet box.
Connect BLACK/WHITE wire from wall control to
BLACK (hot) lead wire from house.
Connect BLACK wire from wall control to BLACK
load wire to fan.
Attach wall control to electrical outlet/box and
secure with screws from original wall switch.
Attach front plate to wall control using 2 screws
provided in the wall control.
tube
outlet box
GREEN/BARE GROUND
BLACK
BLACK
(AC IN from
breaker box)
BLUE
(blue load from fan)
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
page 5
allen wrench
wall bracket
set screw
allen wrench
set screw
canopy
wall control
GREEN
BLACK (to motor)
BLACK/WHITE
(TO POWER supply)
BLUE
(fan rotation)
plate