Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Lights
Replacing side turn-signal bulbs
1. Make sure the headlamp switch is
turned to the OFF position and then
pry the lamp assembly away from
the fender.
2. Rotate the bulb socket
counterclockwise and pull the bulb
straight out.
Install the new bulb in reverse order.
Replacing brake/tail/turn/backup lamp bulbs
The brake/tail/turn/backup lamp bulbs are located in the tail lamp
assembly, one just below the other. Follow the same steps to replace
either bulb:
1. Make sure the headlamp switch is
in the OFF position and then open
the liftgate to expose the lamp
assemblies.
2. Remove the two screws from the
lamp assembly.
3. Carefully remove the lamp
assembly by pulling it rearward to
disengage snap features on the
outward side of the lamp.
4. Twist the bulb socket counterclockwise and remove from lamp
assembly.
5. Pull the bulb straight out of the
socket and push in the new bulb.
6. To complete installation, follow
the removal procedure in reverse
order.
41
2006 Mariner (mrn)
Owners Guide (post-2002-fmt)
USA (fus)
Capítulos
Tabla de contenido
