Filling With Water - Mason & Deck ME2MOGO Manual Del Propietário

USE & OPERATION (CONTINUED)

FILLING WITH WATER

It is ideal to use the Continuous Water Supply Connection to run the unit for long periods of time without
refilling the tank. This also helps prevent pump failure in case the cooler is running with inadequate water
in the tank.
CAUTION: Unplug the unit from the electrical power outlet before filling or emptying the water tank.
Continuous Water Supply Connection:
For a continuous water supply, you will need a garden hose that is connected to a main water supply.
Note: The garden hose is not included. Please make use of a garden hose which is compatible with the
unit connection.
• Locate the male connector at one end of the garden hose. Insert
the garden hose connector into the water inlet valve of the cooler.
Screw and tighten the water inlet valve onto the threaded part of
the garden hose connector, making sure the hose connector is
secured to ensure there will be no leaks. If there is leakage, the
hose and the water inlet valve may not be connected properly.
Try to disconnect, replace and tighten the water inlet valve again.
• When the connection is secured, turn ON the water supply and
the water will flow into the water tank of the cooler.
• The cooler is now set so the water refills automatically.
• When the water tank is full, the water inlet valve will automatically
stop the water supply from overflowing.
• Please open the water valve for minimum flow as too much
pressure could damage the inlet pressure control system.
WARNING:The maximum water inlet pressure is 0.5 MPa.
11
Water inlet value
Garden Hose
EN