General Warnings; Mounting Steps - Iveco Stralis AT-AD Instrucciones De Montaje

CONDIZIONATORE
When installing, be sure to follow carefully the instructions given in this manual.
The manufacturer declines all responsibilities for damage to equipment or people caused by non-standard system
installations or modifications.
Use the conditioner exclusively for the use envisaged by the manufacturer and make no arbitrary changes or alterations to the
appliance.
Never poke your hands inside the grid of the vents and avoid introducing any object into the system.
BEFORE INSTALLING THE SYSTEM, DISCONNECT ALL CONNECTIONS TO THE VEHICLE BATTERY.
Install the roof unit securely to prevent it tipping or falling.
During the assembly phases and the creation of holes in the vehicle, make sure that you do not damage wirings or piping of
systems already installed.
When working near the heat exchangers of the condenser and the evaporator, be careful not to cut yourself on the sharp edges
of the fins.
If the electrical wires have to pass through walls with sharp edges, use protective pipes or specific channels.
Securely fasten the electrical wires, paying special attention to their route along metal walls that conduct electricity; also avoid
contact with sharp elements.
Before beginning installation and after positioning the unit on the roof, check that the openings for the air inlet and outlets on the
condenser are not blocked or covered.
Check whether, following the assembly of the conditioner, it is necessary to change the registration of the height of the vehicle
indicated in the log (contact the vehicle manufacturer).
Switch off the conditioner before using automatic washing devices to clean the vehicle.
Check that the vehicle's battery capacity is at least 170Ah.
N.B.: During installation, it is advisable to use a polyurethane sealant made specially for joint plates, bonnets, canopies and
varnished surfaces, for example: VABER SP5.
Installation operations must be carried out exclusively by a specialised technician who is aware of the dangers connected with
installation and the relative prescriptions.
1. Disconnect the battery.
2. Before positioning the unit on the roof of the vehicle, check that it is possible to access it and that it can support the
weight of the conditioner you intend to install.
3. Remove the vehicle's roof hatch cover and carefully clean its edges so that there are no traces of dirt. Spread sealant
along the edge of the hatch opening (see fig. 3).
4. Position the provided gasket over the newly applied sealant.
Note: Position the gasket starting about halfway along one of the lateral sections of the hatch, so that when glued,
the joint is not on the front or the back section (see fig. 4). Glue the ends of the gasket together using Bostik or a
suitable sealing compound.
Wait for a sufficient time to allow the sealant to dry.
Distribute the sealant in a continuous bead on the roof and along the edge of the hatch, outside the raised profile, in
the housing of the original hatch gasket.
Iveco Stralis_AT-AD_Hi-Road_00_07/2018

GENERAL WARNINGS

MOUNTING STEPS

ENGLISH
11