Direction Of Rotation - PRETUL TALI-12P Manual De Instrucciones

Start Up
General remarks for using the battery
The battery is shipped with NO CHARGE. It is necessary to charge the battery approximately 35 minutes before being able
to use it. A normal charging temperature is from 32 °F to 113 °F. Out of this level the charge gets interrupted until reaching
the right temperature. A normal temperature for discharge / work is from 32 °F to 167 °F. If 167 °F are exceeded, the
electronic control with shut down the tool energy until the temperature reaches the optimum temperature level. When
during work the battery is below the regular voltage, the tool stops functioning. Between charges, give the charger 15
minutes rest. In hot temperatures or after a long job the battery might get too hot to be recharged. Allow the battery to cool
down before trying to charge it again.
Bits or adaptors assembly
• Using one hand, hold firmly the chuck base and with
your other hand loosen the chuck tip turning in a
counterclockwise direction.
• Insert the bit until it stops or remove it whichever the
situation.
• Turn the chuck tip clockwise to fasten the bit.

Direction of rotation

• To bore and screw release the switch and and press the direction
button on the side where marks point towards the chuck.
• To reverse the turn, and unscrew press it on the other side.
• The drill switch will get blocked if the button sits in the middle.
CAUTION • The first time you turn on the drill and after
reversing rotation you might hear a click. This in normal and
does not represent a problem.
CAUTION • To prevent damaging the tool, never reverse
the rotation direction while the drill is running.
Torque Adjust
• To select the desired torque level to screw drive, turn the torque
regulator until it matches the corresponding number with the upper mark:
From 1 to 4 for small screws,
From 5 to 9 for screws on soft materials,
From 10 to 15 for screws on soft and hard material.
• To bore metal, wood or plastic turn the torque regulator into the
ROTATION ( ) position.
• The torque level necessary depends on the type of
CAUTION
screw to be used and the material onto which you are working. If in
doubt use a lower torque and increase gradually until reaching the right
one. An adequate torque prevents damaging the tool.
Chuck
tip
Forward
Torque
regulator
Chuck
base
Reverse
7
ENGLISH