Technical Safety; Installation; Unpacking The Cabinet; Locating The Cabinet - OLITREM AP 600 PO Instrucciones De Utilización Y Mantenimiento


Don't use sharps objects for eliminate ice, this action could damage the tube where circulates the cooling fluid.
The cooling fluid could be in fire and cause injuries on the eyes.

Don't save inside the equipment products with propeller gas (e.g spays tin) and explosive products. Danger of
explosion.

Don't use drawers, doors like support zone.

Alcohol of high percentage just must be save inside the equipment if him was save in container hermetically close
and in upright position.

Don't leave the packing and our components near the children. Danger of suffocation!

Never try to repair the cabinet.

In case of equipments with a lock. Save the key far away from the children.

2.2 Technical Safety

This cabinet has a litle quantity of refrigerant fluid (R600a or R290) not pollutant, but inflammable.
Must be careful for don't damage the tube where circulate the refrigerant fluid during the carriage or installation. The
refrigerant fluid can escape and cause damage on the eyes.
In case of damage:

Must keep the cabinet away from the flames

Ventilate the cabinet for a few minutes

Disconnect the cabinet

Contact the technical services.
The room where the equipment should be installed must be bigger than the quantity of refrigerant fluid the equipment. In
small places and in occurrence of a leak, can form a mixture of inflammable gas.
For each 8g the refrigerant fluid, the room must be at least 1m3. The quantity of fluid refrigerant is in the characteristic
plate of the equipment, inside the cabinet.
The maintenance operations must be done by the manufacturer, its service agent or similarly qualified persons
in order to avoid hazard.
3.

Installation

3.1 Unpacking the cabinet


Take off the plastic packing and remove the protections and pallet.

Take care to see that the cabinet packing is placed out of the reach of children. If possible, try to put the packing in
a place where it could be recycled.

Check whether the cabinet has been damaged during transport.

In order to allow a natural circulation of air you must leave sufficient space between the rear of the cabinet and the
wall, apply in the upper backside the two handles that are supplied.

Apply the four feet of 150 mm with a key 10.

Pull the electrical cable through the opening in the rear grille.

The weight limit for each shelve should be 40 kg/m

3.2 Locating the cabinet


Set the cabinet on the level with feet.

The cabinet should be located in a dry place, on a horizontal surface which can support its weight when fully
loaded.

The whels make it possible to move the cabinet while making cleaning, handling and maintenance easier.

Avoid moving the cabinet when it is fully loaded.

The cabinet should be placed away from any heat source and the rays of the sun so as to reduce power consumption.

Do not obstruct the ventilation grilles.

3.3 Connecting the cabinet


Before connecting the cabinet, check whether the voltage indicated on the cabinet corresponds to the voltage of
your wiring. It is essential that you should connect the cabinet to an earthen power point. Make sure that the cable
does not stay coiled. If the cable is not long enough, it should be replaced by a skilled person (see 7.4). Do not use
an extension or adapter cable.

The cabinet must be placed in such way that the plug is visible.
01.07.2016
2
9