Air Filter; Service And Maintenance - Daikin FWT02CATNMV1 Manual De Instalación

1. Open the front panel.
• Hold the panel at the recesses on the main unit
(2 recesses on right and left sides) and lift it until it
stops.
2. Pull out the air fi lters.
• Push a little upwards the tab at the center of each air
fi lter, then pull it down.
Service Parts
Indoor air fi lter 1.
2.
3.
Indoor unit 1.
2.
1. Open the front panel.
• Hold the panel at the recesses on the main unit (2 recesses
on right and left sides) and lift it until it stops.
2. Remove the front panel.
• While lifting the front panel further, slide it to the right
and pull it to the front side. The left rotating shaft is
detached. Slide the right rotating shaft to the left and
pull it to the front side to remove it.
3. Attach the front panel.
• Align the right and left rotating shafts of the front panel
with the grooves and push them all the way in.
• Gently close the front panel. (Push both ends and the
center on the front panel.)
• Don't touch the metal parts of the indoor unit. It may cause an injury.
• When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
• For cleansing, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing
compound, scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front panel is securely fi xed.

AIR FILTER

Recess on
main unit

SERVICE AND MAINTENANCE

Remove any dust adhering to the fi lter by using a vacuum cleaner or wash in lukewarm
water (below 40°C/104°F) with a neutral cleaning detergent.
Rinse the fi lter well and dry before placing it back onto the unit.
Do not use gasoline, volatile substances or chemicals to clean the fi lter.
Clean any dirt or dust on the grille or panel by wiping it with a soft cloth soaked in
lukewarm water (below 40°C/104°F) and a neutral detergent solution.
Do not use gasoline, volatile substances or chemicals to clean the indoor unit.
! CAUTION
3. Clean or replace each fi lter.
• When shaking off remaining water, do not wring the
fi lter.
4. Set the air fi lter as they were and close the front
panel.
• Insert claws of the fi lters into slots of the front panel.
Close the front panel slowly and push the panel at the
3 points. (1 on each side and 1 in the middle.)
• The air fi lter have a symmetrical form in the horizontal
direction.
FRONT
Maintenance Procedures
Rotating
shaft
1-9
Recess on
main unit