Inserting / Replacing The Batteries; Use And Functions - KLAN DUAL POWER K-DP-JKT-1000 Instrucciones De Uso

EN

INSERTING / REPLACING THE BATTERIES

If the batteries are no longer fully functional (reduced heating times;
battery fails to recharge), it is necessary to replace them.
To replace the batteries, proceed as follows:
1. Open the batteries pocket on the Jacket (1.5).
2. Disconnect the battery cable (1.3) from the Jacket (1.4).
3. Remove the battery and replace it with new one. Dispose of the
old batteries properly.
4. Connect the battery cable to the gJacket and close the pocket.

USE AND FUNCTIONS

The Dual Power Jacket/Trousers has four operating modes:
POWER-OFF - LEVEL 1 - LEVEL 2 - LEVEL 3 - LEVEL 4. These are
clearly visible on heating level display (1.1) - The corresponding LED
color refers to the selected Level.
The Dual Power Jacket/Trousers has a control pad with one control
button (1.2) to set the 4 levels of heating. These can be used to
choose between 4 different heat levels. The Dual Power Jacket/
Trousers is switched off when the LED display is not lit.
Turning the device on:
Turning the device off:
Manual adjustment:
with a lengthy press of the control button (3
sec.) the Dual Power Jacket/Trousers is
activated to the highest heating level.
with a lengthy press of the control button (3
sec.) the Dual Power Jacket/Trousers is
getting off, no LED marked.
Each time the control button is pressed , the
heat level is increased, White led minimum
level , Blue led medium level , Violet led high
level, Red led maximum level. With a new
pressure the Jacket/Trousers returns at the
minimum level.
10