Nutricia Flocare Infinity + Instrucciones De Funcionamiento página 89

UK-IE
Condition
• The feeding set is not inserted cor-
• The air sensor area is dirty( Fig 1,
BATT
• The battery capacity is too low.
the pump
remains working
Battery, "E" and "F"
• Battery failure.
flashing
FILL SET
• The pump is priming the set.
OCC IN • The pump detected an upstream
• The pressure sensor area is dirty (
• The pump detected a
OCC OUT
• The pressure sensor area is dirty
OCC OUT
• Calibration not yet completed
(repeated)
LOCK • Only the current feeding
ER01 - ER99
• The self test detected an electronic
ER40
• Keypad pressed or stuck during
No plug symbol visi- • The wall outlet doesn't work.
ble, while the pump
• The adaptor is damaged.
is connected to the
mains.
ZMNL900617_AW.indd 87
Cause
rectly.
position 8).
The pump is not able to deliver
highly viscous fluids at high flow
rates with the present charge level
of the battery.
occlusion between the pump and
the feeding bag.
Fig 1, position 5 & 6).
downstream occlusion between the
pump and the patient.
(Fig 1, position 5 & 6).
on the current feeding set
schedule is allowed for this patient.
Another feeding program is not
allowed by your healthcare profes-
sional.
error
pump start up.
Correction
• Make sure the feeding set is properly inserted in the
pump. (Fig 5a - 5d)
• Make sure the air sensor is clean.
• Connect the adaptor to the pump and mains and charge
the pump for approx. 6 hours. During charging the pump
can be used.
• Turn the pump "off", contact your healthcare provider or
refer the pump to service.
• Press the "fill set" key another time to stop the pump and
bring it back in the hold mode.
• Stop the alarm by pressing the "start/stop" key.
• Remove the feeding set out of the pump and check the
permeability by flushing the line.
• Re-insert the feeding set in the pump and restart.
• Clean the sensors, reinsert the feeding set in the pump
and restart the pump.
• Stop the alarm by pressing the "START/STOP" key.
• Remove the feeding set out of the pump and check the
permeability by flushing the line.
• Check the permeability of the feeding tube.
• Re-insert the feeding set in the pump and restart.
• Clean the sensors, reinsert the feeding set in the pump
and restart the pump.
• Stop the alarm by pressing the "start/stop" key.
• Start the pump by pressing the "start/stop" key and let it
run only briefly.
• Stop the pump by pressing the "start/stop" key insuring
that there has been no occlusion out alarm.
• Remove the feeding set from the pump and reinsert the
feeding set in the pump.
• Restart the pump by pressing the "start/stop" key.
• The programming feature is blocked in the set up mode
of the pump. Ask your healthcare professional to modify
this setting.
• Turn the pump "off", make sure the pump door is closed
and switch the pump back "on". If the error persists,
contact your healthcare provider or refer the pump to
service.
• Restart pump by ensuring keypad is not pressed.
• Connect the pump to another wall outlet.
• Contact your healthcare professional or
Nutricia subsidiary to replace the adaptor.
-87-
10/11/16 16:18