Assembly Instructions - Whalen WSLWFP54-6 Manual Del Usuario

ASSEMBLY INSTRUCTIONS

13a. Pick up the upper back panel (Q) and align the drilled holes
with the pilot holes on the back of the top panel (A). Attach
the upper back panel (Q) in place with the provided washer
head screws (EE).
13b. Align and attach two lower back panels (R) to the side
frames (D and E) and lower partition panels (F and G) with
the provided washer head screws (EE), using the plots holes
as a guide.
Hardware Used
Washer Head Screw
EE
14a. Carefully stand the unit upright.
14b. Insert four shelf pins (II) into the desired holes inside
each side compartment. Make sure you place the 4 shelf
pins in the same level so the shelf is not tilted. Tilt and
rest the adjustable shelves (M) onto the shelf pins (II).
14c. Plug the cam lock covers (HH) onto the visible cams
locks (AA) to conceal the cams.
Hardware Used
HH Cam Lock Cover
II Shelf Pin
15. Attach one handle (JJ) to the front side of each door (N and O)
with the provided handle bolts (KK).
Hardware Used
Handle
JJ
KK Handle Bolt
13
EE
Q
C
UP
R
x 32
E
14
G
x 18
M
D
HH
x 8
15
x 2
N
x 4
O
10
ASSEMBLY INSTRUCTIONS
Follow these steps if you want to change your fireplace door
panels from wood (S) to glass (P). Otherwise, skip to Step 17.
16A. Take the left door (N) and loosen the screws on the inside of
the door frame.
16B. Rotate the clips to remove the old panel.
D
16C. Insert the new panel, then rotate the clips and tighten the
UP
screws to secure the panel in the door frame.
R
16D. Repeat this process with right door (O).
F
17a. Pick up left door (N) and attach the extended hinge arms to the
hinge bases installed on the left side frame (D). Loosen the bolt on
the back of the hinge base for an easy fit. Align and insert the "U"
slot on the hinge arm under the bolt head on the back of the hinge
II
base. Make sure that both door hinges engage and function properly.
E
Tighten the bolt on the hinge base to lock the hinges in place.
17b. Repeat the same procedure to attach the right door (O) at the
opposite side.
17c. Open and close the doors to make sure they are aligned and shut
correctly. If necessary, adjust the screws for a good fit. Refer to the
hinge sticker on the door for adjustment.
M
II
17d. Stick the rubber bumpers (RR) at the outer corners of both doors
(N and O) where they meet with the partition panels (F and G).
Hardware Used
RR
Rubber Bumper
Installing the fireplace insert
KK
18. Lift the fireplace insert carefully into the back of the assembled
mantel and center it in the opening. DO NOT drag the insert
across the bottom panel (B) as it may scratch the unit.
x 2
JJ
16
N
O
N
O
17
G
O
D
N
x 4
RR
18
R
B
L
Electric
Firebox
11
S
P
1
R