Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Section 5: Maintenance
An O-Ring
Maintenance Kit is provided with your pressure
washer which includes replacemeut o-rings, rubber washer
and water inlet filter. Refer to the instruction
sheet provided
in the kit to service your unit's o-rings, Note that not all of
the parts in the kit will be used on your unit.
To remove a worn or damaged o-ring, use a small flathead
screwdriver
to get underneath the o-ring and pry it off'.
Pump
Maintenance
Changing
Pump Oil
Change oit every 50 hours or once yearIy, whichever
occurs first,
NOTE:You
must purchase a premeasured
bottle of pump
oil, item number
190586GS, by contacting the nearest
authorized
service center.
Change
pump
oil as follows:
I.
Drain engine oil and fuel from pressure washer.
2.
Use a 8mm allen wrench to remove black pump oil cap
between high pressure outlet and garden hose inlet
(Figure 15).
Oii Cap
3.
Tilt pressure washer to drain oil into an approved
container
until it drips slowly from pump.
4.
Tilt pressure washer in opposite direction
and empty
premeasured
pump oil bottle into same opening (a
small funnel may be helpful).
5.
Install black pump oil cap and tighten firmly.
6.
Set pressure washer in upright peairJon.Add fuel and
engine oil.
ENGINE
MAINTENANCE
See the engine owner's manual for instructions
on how to
properlymaintain the engine.
• Thoroughly wash exposed areaswith soap and water,
KEEP OUT OF REACH OF CHILDREN, DON'T
POLLUTE. CONSERVE RESOURCES.RETURN
USED OIL TO COLLECTION CENTERS.
Data
Plate
Data plate information
is very important if you need help from
our Customer Service Department
or an authorized service
dealer,
• The data plate (Figure 16) is located on the base of the
pressure washen For future reference, please copy the
model, revision, and serial number of the pressure washer
in the space below.
,
Copy Model
Number Here
MOD_EL
]
Copy Revision
Here
REV NO
SERIIAL
GPM
Copy Ser a
i
Number
Here
E
E
m
Tabla de contenido
