Getting Started - Altec Lansing M202 Guia Del Usuario

Getting Started

Place your Altec Lansing Octiv Duo speaker system on a desk, bookshelf,
counter, or other hard surface.
WARNING In order to prevent accidentally dropping your iPhone or iPod
players, be sure to remove them from the docking stations before picking
up the speaker system.
How to Install the AC Adapter
1
Connect the AC adapter cable plug
into the speaker system's jack.
The jack is located on the back of the
system and is labeled DC IN 5V.
2
Plug the AC adapter into the
wall outlet.
WARNING Use of another AC adapter
may damage the product. Use only
the supplied AC adapter (available on
www.alteclansing.com).
4
How to Connect the Full-featured Remote Battery
The full-featured remote battery (included) is installed at the factory.
However, there is a piece of plastic film inserted between the battery and
the remote's contact to prevent the battery from draining during shipping.
To remove this film, follow the steps below:
1
Pull the battery holder out about halfway.
The battery door is located on the lower end of the remote. Use your
thumbnail to pull the tab to open the battery holder.
2
Pull the plastic film out of the remote.
3
Push the battery holder back into the remote, making sure the
battery stays in place.
NOTE Please discard used batteries properly.