Nuna zaaz Manual De Instrucciones página 7

Assemble Footrest onto Seat
1
- Slide down the lock behind the flap and lift the flap
completely. The seat automatically rises up to its highest
position. (2)
2
- Attach the footrest on one side of the flap and then flex
the footrest to attach it on the other side. (4)
3
- Lower the flap down into position. Listen for the click as
the lock clicks back into position.
Assemble Seat Cushion onto Seat
1
- First remove the tray, the armbar and the harness
restraint if necessary.
2
- Insert the cushion retainer into the slot. Listen for the
click sound means locked. (5)
3
- Then place the seat cushion onto the seat. (6)
Assemble Harness Restraint onto Seat
WARNING When used as a high chair, the child must always
wear the harness restraint correctly fitted and adjusted.
The chair complies with the high chair European standard
(EN14988:2017 & BSEN12520) only when the harness is fitted.
1
- Insert waist clips into the lower backrest holes (around
the seat cushion, when cushion in use) and listen for a
click. (7)
2
- Insert shoulder harness clips into the upper backrest
holes and listen for click. (7)
3
- Insert the remaining crotch clip (through the seat
cushion, when cushion in use) into the inner of two holes
in the sitting surface of the seat and listen for a click. (7)
4
- Check that the harness attachment is secure by pulling
on each attachment point.
9 ZAAZ instructions
Assemble Armbar onto Seat
WARNING The armbar alone DOES NOT guarantee the
restraint of your child!
1
- With the arm bar tilted up, hook both the ends of the arm
bar into the holes in the backrest to the right and left of
the seating area. (8)
2
- Rotate the armbar down, locking the ends of the armbar
to the seat back and insert the front center attachment
into the outer slot until it locks in place, listen for the
click. (9)
3
- Check that the armbar is secure:
• by pulling out on the front of the arm bar.
• by pulling up on the front center attachment
Assemble Tray onto Armbar
WARNING The tray and the armbar alone DO NOT
guarantee the restraint of your child!
1
- Position the tray over the armbar. Insert the tabs at the
back of the tray into the slots between the armbar and
the backrest of the seat, as illustrated. (10)
2
- Push the tray down until the side clips fasten around the
armbar. (11)
3
- Check that the tray is secure by pulling up on the front of
the tray.
ZAAZ instructions 10