Fisher&Paykel AquaSmart Manual De Instrucciones página 41

Before you ca_ for service
(}i
:: Checkthat the cord water suppRy has been turned on_
'four cold water temperature may exceed the recommended bruits (refer to
:: Installation instructions pages 6 - 11)_
:: £heckthat the inlet hose filter is not blocked_
..... C .............................................
.... Che c th et have been _ or, thecorrect faucets.
The flow rate of the supply water may be too slow_
_q
©
move freely.
Check that the washer is not siphoning (refer to Installation instructions pages 6 - 11)_
'four washer has a suds build-_up_ T:oo much detergent may have been used for the
amount of soil in the Ioad_
Ensure that you are using a HE Low Sudsing or Front Loader type detergent_
V%it for suds to dissolve (about 20 minutes)_
Rinse clothing using the RINSE and SPIN cycle, or run through another cycle_
Checkthat the lid is closed.
Press START/PAUSE_
Center,
Single beep every second and ooo
3, Check your washer is level (refer to installation instructions pages 6 - 11).
4_ Remove load and retry,
5. Put through a RINSE and SPIN cycle_
6, If the fault re--occurs repeat steps 1 and 2,
If the washer still will not work, call your Fisher & Paykel Dealer or Authorized Service Agent to
arrange service (refer to page 45),