Denon Professional AUDIO COMMANDER Guia Del Usuario página 8

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Operation
Wireless Microphone Setup
To use a wireless microphone, follow these setup steps:
1. Ensure 2 new AA alkaline batteries are installed in the wireless microphone.
2. Pair the wireless microphone (found in the side compartment) to W. Mic Receiver 01
on Audio Commander.
a. Turn on Audio Commander and the wireless microphone.
b. Select a channel with the best reception using the Up/Down buttons on the
receiver.
c. Place the wireless microphone IR sensor (found above the power button) near the
receiver's IR LED and press the Set button on the receiver. Wait for about 3
seconds until the IR LED stops flashing. When it finds an interference-free
channel, the RF LED will illuminate on the receiver showing the mic is matched to
that channel.
3. Adjust the wireless microphone gain using the W. Mic 1 knob on Audio Commander.
4. As you speak, watch the AF indicator on W. Mic Receiver 01 to make sure a signal is
being received.
Note: Make sure to turn the Browse knob and select the appropriate W.Mic source
in order to output a signal.
To set up the second wireless microphone, follow the same steps above for pairing to W.
Mic Receiver 02.
Headset Microphone Setup
To use the included headset microphone, follow these setup steps:
1. Ensure new batteries are installed in the beltpack transmitter.
2. Connect the headset microphone to the beltpack transmitter.
3. Pair the beltpack transmitter to the wireless receiver on Audio Commander.
a. Turn on Audio Commander.
b. Turn on the beltpack transmitter.
c. Select a channel with the best reception using the Up/Down buttons on the
Audio Commander receiver.
d. Lift the cover from the compartment and place the beltpack transmitter IR sensor
near the receiver's IR LED. Press the Set button on the receiver. Wait for about 3
seconds until the IR LED stops flashing. When it finds an interference-free
channel, the RF LED will illuminate on the receiver to show that the beltpack
transmitter is matched to that channel.
4. Adjust the microphone gain using the W. Mic knob on Audio Commander.
5. As you speak, watch the AF indicator on the receiver to make sure a signal is being
received.
Note: Make sure to turn the Browse knob and select the appropriate W.Mic source
in order to output a signal.
8
Tabla de contenido
loading

Tabla de contenido