Worx LANDROID L Guia De Instalacion página 14

Open the keypad window
by pressing the ACCESS
button on the top of your
Landroid
Press and hold down the
Power ON/OFF
until the Landroid ® L turns on.
Press the key and close
the keypad window: your
Landroid L will now find its
®
way to the charging base.
Watch the Landroid
returns to the charging base
and modify the positioning
of the boundary wire if
necessary. When the
Landroid L successfully
®
returns to the charging base,
this means the installation has
been successfully completed!
Now your Landroid L will start
®
to fully charge.
14 NotE: If your Landroid
ACCESS button and close keypad window to send it back to mowing.
EN
• If your Landroid
outside its territory, it
will not move and the
Warning
display will indicate
"out of cutting area"
error. Just move it inside
its territory and repeat
step 2.
NotE: Please refer to the Programming and troubleshooting Guide for more information.
2
L.
®
key
L as it
®
L is in the charging base during a time you have programmed it to mow, then simply press the
®
L is • If your Landroid
®
inside its territory but
the display says "out
of cutting area" , and the
LED is on, it means you
clamped the boundary
wire ends incorrectly.
Just reverse them.
L is • Your Landroid L should
® ®
always remain switched
on. If you ever need to
turn it off, then make sure
you place it within its
boundary area before you
switching it back on again.
• Should your Landroid L
®
stop operating
unexpectedly, just press
the ACCESS button, open
its keypad window, press
its ON/OFF key to ON,
press
correct the problems,
0 button, close its keypad
window.