Instructions On Adapter Kit For 6 Lights - Kasco LE275 Manual Del Proprietário

bolt through the light mounting hole in the lower fl oat
bracket as shown in Figure 11.
Fig.10
STEP TWO:
Install the 1/4" Flat Washer, 1/4" Lock Washer and
1/4" Nut against the lower fl oat bracket as shown in
Figure 12. Tighten the nut until snug using the 7/16"
Wrench.
Fig.12
STEP THREE:
Adjust the angle of the light as desired and tighten the
two brass screws on the sides of the fi xture until snug.
Do not over tighten. It is best to have all three fi xtures
at the same angle.
STEP FOUR:
Repeat steps 1 through 3 for the remaining two
fi xtures. The completely assemble light fi xture is
pictured in Figure 13.
Fig.13
STEP FIVE:
Using the nylon cable tie provided, tie the light kit
power cord to a fl oat bracket or rope opposite the
fountain power cord. This will keep the cord from
being damaged by the fountain and balance the unit
properly.
6
Light bracket
mounting hole.
Fig.11
fl oat bracket
fl at washer
lock washer
nut
STEP SIX:
Each light fi xture and cord entrance must be
submerged at least 25mm in order for lights to operate
properly.
STEP SEVEN:
Upon installation of the assembled unit, connect your
lighting package to your control box. It must be
connected to an RCD protected circuit 220Vac 50/60
hz.
Instructions On Adapter Kit For 6
Lights
Instructions for attaching 2 LE375 light kits on
Model 8400EJF, 3.1EJF Aerating Fountains
Adapter kit (Part# 840322 sold separately) includes:
1. Lower fl oat brackets (Qty 6)
2. 3/8" washers (Qty 3)
3. Round Spacers (Qty 6)
4. 1/4" x 2" Stainless Steel Bolts (Qty 6)
Part 1
Part 3
Part 2
1. Turn the unit upside down. Loosen and remove the
3/8" nuts on the three 9" bolts that are closest to the
motor unit. Place 2 Lower Float Brackets(Part #1) and
one 3/8" washer(Part #2) on each of the 9" bolts over
the bottom screen clips and replace the 3/8" nut.
Part 4