Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Dispensing Water
IMPORTANT:
Dispense at least 1 qt (1 L) of water every week to maintain
■
a fresh supply.
If the flow of water from the dispenser decreases, it could
■
be caused by low water pressure.
With the water filter removed, dispense 1 cup (237 mL)
■
of water. If 1 cup (237 mL) of water is dispensed in
8 seconds or less, the water pressure to the refrigerator
meets the minimum requirement.
If it takes longer than 8 seconds to dispense 1 cup
■
(237 mL) of water, the water pressure to the refrigerator
is lower than recommended. See the "Water Supply
Requirements" and "Troubleshooting" sections for
suggestions.
To Dispense Water—Standard:
1. Press a sturdy glass against the water dispenser paddle.
2. Remove the glass to stop dispensing.
NOTE: The Fill button does not enable standard dispensing.
It only functions in Measured Fill or Favorite Fill mode.
To Dispense Water—Measured Fill:
Measured Fill allows you to dispense a specified amount
of water with the touch of a few buttons.
1. Put a sturdy glass under water spout. Touch MEASURED
FILL to activate.
NOTE: The amount of water you select will be dispensed.
Make sure the container can hold the entire volume. If ice
is in the container, you may need to adjust your selection.
2. Touch MEASURED FILL to turn on, then touch to select
8 oz (0.2 L), 16 oz (0.5 L), or 24 oz (0.7 L). Touch the fourth
time to exit Measured Fill display.
3. Touch FILL (center button) or press paddle and the selected
amount of water will be dispensed.
NOTES:
The Measured Fill dispenser will automatically time out after
■
1 minute of inactivity.
You can refill several glasses with the same measurement by
■
continuing to touch FILL (center button) after each glass fill.
26
Measured Fill options are listed in the following chart:
Units
Ounces
Cups
Liters
0.2
NOTE: Most coffee cups (commonly 4 to 6 oz [118 to 177 mL]
per cup) are not the same size as a measuring cup (8 oz
[237 mL]). You may need to recalibrate Measured Fill to
underfill or to avoid unintentionally overfilling coffee cups.
4. Dispense water.
NOTE: While dispensing water, the flow of water will
automatically stop once the desired volume has been
dispensed.
Press a sturdy glass against the dispenser paddle below
■
the water spout.
Place the glass below the water spout and touch FILL for
■
hands-free dispensing.
5. To pause dispensing before the selected volume has been
dispensed, touch FILL a second time or touch the water
dispenser paddle. Touch FILL or paddle again to resume
dispensing remaining amount.
NOTE: If you stop dispensing before the desired volume has
been dispensed, the display will turn off after 1 minute. If you
have not resumed by then, it will reset back to the original
amount.
6. To select a new volume or start dispensing the same volume
again, you must first finish dispensing the selected volume or
turn off the Measured Fill feature (either by waiting 1 minute
so it will automatically turn off, or by touching CUBED ICE
or CRUSHED ICE to manually turn it off), and then select
Measured Fill again.
To Dispense Water—Favorite Fill:
Favorite Fill allows you to dispense a preferred amount of water
with the touch of a few buttons.
1. Put a sturdy glass under water spout. Touch FAVORITE FILL
to activate.
NOTE: The amount of water you select will be dispensed.
Make sure the container can hold the entire volume. If ice
is in the container, you may need to adjust your selection.
2. Touch FAVORITE FILL to turn on, then touch to select
Favorite 1 or Favorite 2. Touch the third time to exit
Favorite Fill display.
3. Touch FILL (center button) and the selected amount of water
will be dispensed.
8
16
1
2
0.5
OR
24
3
0.7
Tabla de contenido
