Servicing And Maintenance - KNIPEX DigiCrimp 97 52 63 DG Manual De Instrucciones

Operating Instructions
Four-indent crimping tool DigiCrimp® with digital display and wear monitoring
Display Cause
The display
E1 recalibration
their limit of wear.
Calibration or recalibration at a higher
adjustment value than on initial factory
E2
calibration (too much play between the punch
and gauge).

13. Servicing and maintenance

Make sure that your hand crimper is in a clean and proper state before use. Remove any crimping residues
from between the crimping jaws and contact bushing. Lubricate the joints regularly with machine lubricant,
and protect them from soiling. Make sure that all of the pins are secured by retaining rings.
Always have the crimper manufacturer or an authorised repair shop repair your four-indent crimper.
CE-tested according to EMC
EN 55014-1:2006,EN 55014-2:1997+A1:2001, Cat. III
Test conducted by:
CE-LAB GmbH [DAT-P-209/05-00]
Am Hammergrund 1
98693 Ilmenau, Germany
FCC testing
FCC 47 CFR Part 15 Subpart B Class B
Test conducted by:
Herberg Service Plus GmbH [Reg. No. 96997]
European Compliance Laboratory (ECL)
Nordostpark 51, 90411 Nürnberg, Germany
Repairs / Service
Rev.: 2016-06-10
shows E1 after
Your crimp dies have reached
–
KNIPEX-Werk
C. Gustav Putsch KG
Oberkamper Straße 13
42349 Wuppertal - Germany
Solution
correct
The crimper dies are worn out. Send in your
crimper for inspections.
Repeat calibration or recalibration with the
gauge supplied (see 8 or 9).
Tel.: +49 2 02 / 47 94 0
Fax: +49 2 02 / 47 50 58
Web: www.knipex.de
email: [email protected]
EN
10 / 10