Shindaiwa T282 Manual De Instrucciones página 8

Assembly (continued)
Adjust Throttle Lever Free Play
The throttle lever free play should be
approximately 4-6 mm. Make sure that the
throttle lever operates smoothly without
binding. If it becomes necessary to adjust
the lever free play, follow the procedures
and illustrations that follow.
1. Loosen the air cleaner cover knob and
remove the air cleaner cover.
2. Loosen the lock nut on the cable
adjuster.
3. Turn the cable adjuster in or out as
required to obtain proper free play.
4. Tighten the locknut.
5. Reinstall the air cleaner cover.
Install trimmer head T282
Output
shaft
1. Turn the trimmer over so that the gear
case output shaft faces UP.
2. Remove and discard the black plastic
protective cap from the output shaft.
3. Rotate the holder until the hole in the
holder aligns with the notch on the
gear case. Use the long end of the hex
wrench to lock the holder and output
shaft.
4. While holding the hex wrench, thread
the trimmer head onto the output shaft,
turning counter-clockwise. Using hand
pressure only, tighten the trimmer head
firmly on the output shaft.
8
Throttle Lever Free Play
Cable
Adjuster
Adjust as required to obtail 4-6 mm
free play
Retaining Plug
Holder
Hex Wrench
The trimmer head has a left-hand thread.
For removal turn the trimmer head
clockwise.
5. Remove the hex wrench.
6. Adjust the trimmer line length to reach
no further than the line cutter on the
cutting attachment shield. Trim to the
correct length if necessary.
completely assembled and ready
for use with a trimmer head.
4-6 mm
Throttle Free
Play
Lock Nut
IMPORTANT!
The unit should now be
Remove air cleaner cover
To install a trimmer
head onto a T282X,
first remove the shaft
bolt, bolt guard
(see the next page).
WARNING!
A standard grass trimmer with
a loop handle should NEVER be oper-
ated with blade-type attachments.
For blade use the trimmer must be fit-
ted with a bicycle-type handlebar or
a barrier bar that is located in front
of the operator to reduce the risk of
the operator from coming in contact
with the cutting attachment (per ANSI
B175.3). When using a blade, the unit
must also be equipped with a harness
or strap.