Fm Mode - Chal-tec auna Connect System Manual Del Usuario

FM MODE

1. Press MODE button repeatedly to select FM mode.
2. For initial use, it will start at the beginning of the FM frequency range
(87.50 MHz).Otherwise, the last listened FM station will be selected.
3. To manually change the FM frequency: while FM frequency shows up,
press TUNE/VOL. button to activate tuning function of SCROLL/SELECT
knob, and then turn SCROLL/SELECT knob clockwise or anticlockwise to
change the frequency by 0.05 MHz per step.
4. To automatically scan: while FM frequency shows up, press TUNE/
VOL. button to activate tuning function of SCROLL/SELECT knob first,
and then turn SCROLL/SELECT knob clockwise or anticlockwise. Press
SCROLL/SELECT knob, your radio will skip forward or backward until it
reaches the next available station.
Scan settings
This enables you set FM scans, stop at stations with strong signal or stop
at any available station. By default, FM scans stop at any available station.
This may result in a poor signal-to-noise ratio (hiss) from weak stations.
1. Press MENU button, turn SCROLL/SELECT knob to select "Scan setting,"
and then press SCROLL/SELECT knob to confirm.
2. Display will show "Strong stations only?" Turn SCROLL/SELECT knob to
select"YES," and then press SCROLL/SELECT knob to confirm. The scans
stop only at stations with good signal strength.
3. Turn SCROLL/SELECT knob to select "NO," and then press SCROLL/
SELECT knob to confirm. The scans stop at any available station. This
may result in a poor signal-to-noise ratio (hiss) from weak stations.
Audio settings
By default, all stereo stations are reproduced in stereo. For weak stations,
this may result in a poor signal-to-noise ratio (hiss).
1. To play weak stations in mono, press MENU button, turn SCROLL/
SELECT knob to select "Audio setting," and then press SCROLL/SELECT
knob to confirm.
EN
63