FIBARO CO SENSOR Manual De Instrucciones página 8

Warnings
Failure to observe recommendations included in the manual may cause risk to life and health
or malfunction of the device.
The manufacturer, Fibar Group S.A. will not be held responsible for any loss or damage resulting
from not following instructions of the manuals.
Risk of malfunction as a result of tampering with the device.
The device should be installed below the ceiling level.
The device should not be installed: in a bathroom, next to heat sources, within range of kids,
obstructed from possible carbon monoxide sources, in direct sunlight.
The device is not a substitute for appropriate ventilation and exhaust systems.
Do not paint the device.
The device should be cleaned with a slightly damp cloth or moistened tissue.
Using batteries other than specified may result in explosion. Dispose of properly, observing
environmental protection rules.
Replace the device before date on the front or if sensor error is detected.
Place of installation (page 4)
Install the device on the wall, at least 30 cm (1 ft) away from the corner.
Recommended height of installation is dependant on the purpose of the room and height at
which head typically is.
First launch (page 5)
1) Open the casing by turning the cover counter-clockwise (Fig. 1).
2) Take off the cover (Fig. 2).
3) Remove the battery blocker and check if the battery is placed correctly (Fig. 3).
4) Proper powering up will be confirmed with a short beep (Fig. 4).
5) Download FIBARO for HomeKit app from the App Store.
6) Open the FIBARO for HomeKit app and tap icon.
7) Application will guide you through the pairing process.
8) Mount the cover on a wall (Fig. 5).
9) Attach the device to its cover (Fig. 6).
10) Turn the device clockwise to close it (Fig. 7).
Setup Code
You will find the Setup Code on the back of this guide.
Remember to keep it in a safe place. You may need it in case of re-pairing.
8