Energy Plus CE163TW Manual De Usuario página 8

Maintenance
As needed, or every six months minimum.
1. WARNING! Before removing grill, turn the electrical power off
at the electrical panel board (circuit breaker or fuse box). Lock or tag
the panel board door to prevent someone from accidentally turning
the power on while you are working on the heater. Failure to do so
could result in serious electrical shock, burns, or possible death.
2. Allow the heater to cool for 20 minutes before proceeding.
3. It is important that you verify power has been turned off and no
power is going to the heater before proceeding. Circuit breakers
are often not marked correctly and turning the wrong breaker off
could mean electricity is flowing to the heater, even if the heater
does not appear to be working. If you are uncomfortable working
with electrical appliances, unable to follow these guidelines, or do
not have the necessary equipment, consult a qualified electrician.
4. Once you verify the power has been turned off correctly,
proceed to the next step.
5. Remove screws and take off grill.
6. Wash grill with hot soapy water and dry immediately.
7. While holding fan (to avoid damage or bending), use a hair dryer
or vacuum on blow cycle to blow debris through the top element
(Do not touch element).
8. Do not use or spray any liquid cleaning products on your heater.
9. Do not lubricate the motor.
10. Vacuum fan area without touching the elements.
11. Replace grill and secure with screws.
12. Turn power back on at the electrical panel board.
13. Set temperature to desired setting.
LIMITED ONE-YEAR WARRANTY: Cadet will repair or replace any Cadet
product, including thermostats and electronic controls, found to be defective
within one year after the date of purchase.
Extended Product Warranty
LIMITED FIVE-YEAR WARRANTY: Cadet will repair or replace any Energy Plus
(CE) series heater found to be defective or malfunctioning from first date of
purchase through the fifth year.
These warranties do not apply:
1. Damage occurs to the product through improper installation or incorrect
supply voltage;
2. Damage occurs to the product through improper maintenance, misuse,
abuse, accident, or alteration;
3. The product is serviced by anyone other than Cadet;
4. If the date of manufacture of the product cannot be determined;
5. If the product is damaged during shipping through no fault of Cadet.
6. CADET'S WARRANTY IS LIMITED TO REPAIR OR REPLACEMENT AS SET
OUT HEREIN. CADET SHALL NOT BE LIABLE FOR DAMAGES SUCH AS
PROPERTY DAMAGE OR FOR CONSEQUENTIAL DAMAGES AND/OR
INCIDENTAL EXPENSES RESULTING FROM BREACH OF THESE WRITTEN
WARRANTIES OR ANY EXPRESS OR IMPLIED WARRANTY.
7. IN THE EVENT CADET ELECTS TO REPLACE ANY PART OF YOUR CADET
PRODUCT, THE REPLACEMENT PARTS ARE SUBJECT TO THE SAME
WARRANTIES AS THE PRODUCT. THE INSTALLATION OF REPLACEMENT
PARTS DOES NOT MODIFY OR EXTEND THE UNDERLYING WARRANTIES.
REPLACEMENT OR REPAIR OF ANY CADET PRODUCT OR PART DOES NOT
CREATE ANY NEW WARRANTIES.
8
MAINTAININg YOUR HEATER
About the Manual Reset Temperature Limit Control
The heater is protected by a temperature-limiting control. The manual
reset temperature limit control is designed to open the heater circuit
when excessive operating temperatures are detected. The problem
must be assessed (typically the heater is blocked or needs cleaning)
and the limit must be reset to resume operation.
Resetting the Manual Reset Temperature Limit Control
If the manual reset limit control has opened the heater circuit due to
excessive operating temperatures, the heater will not work until the
manual reset limit button is pressed.
The "manual reset limit
button" is the red button
located on the upper left
side of your heater, behind
the grill louvers located
just above the digital
temperature display.
After allowing the unit to
cool for at least 10 minutes
and resolving the problem
causing the limit to trip (typically the heater is blocked or needs
cleaning); use a narrow object such as a ball-point pen to access
the manual reset button through the upper-left center section of the
heater grill. Press FIRMLY and be sure to listen and feel for a click,
indicating it has been reset.
Warranty
8. These warranties give you specific legal rights, and you may also have
other rights which vary from state to state. Cadet neither assumes, nor
authorizes anyone to assume for it, any other obligation or liability in
connection with its products other than as set out herein.
If you believe your Cadet product is defective, please contact Cadet
Manufacturing Co. at 360-693-2505, during the warranty period, for
instructions on how to have the repair or replacement processed. Warranty
claims made after the warranty period has expired will be denied. Products
returned without authorization will be refused.
Parts and Service
Visit http://support.cadetco.com for information on where to obtain Parts
and Service.
Reduce-Reuse-Recycle
This product is made primarily of recyclable materials. You can
reduce your carbon footprint by recycling this product at the end of
its useful life. Contact your local recycling support center for further
recycling instructions.
©2012 Cadet Manufacturing Co.
Manual Reset
Limit Button
+
NO
F
NO FAN
SLEEP
NO HEAT
FAN
ONLY
Printed in U.S.A. Rev. 06/12 #720055
HEAT