Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Æ Pivot the grip to the rear.
Æ Pivot the operating panel to the front.
Clean areas which cannot be accessed using
compressed air, if necessary. Compressed air
can be obtained in small aerosol cans.
Æ Clean the sensors with the brush supplied.
Æ Close the machine in the reserve sequence after
cleaning.
Adjusting the Pressure of the Infeed Plate
The bank note counter is set-up at the factory to draw
the bank notes in properly. If bank notes are no
longer drawn in properly, adjust the pressure exerted
by the infeed plate.
18
The adjusting screw to alter the pressure exerted by
the infeed plate is located at the rear.
28 Adjusting screw
29 Locking screw
The adjusting screw is secured against being adjust
ed inadvertently by means of a locking screw.
Æ Switch the bank note counter off.
Æ Loosen the locking screw using the screwdriver sup
plied.
Æ Adjust the pressure of the infeed plate so that the
bank notes can be pushed under the rubber rollers by
exerting a little force.
Æ Tighten the locking screw.
G
28
29
Tabla de contenido
