Altec Lansing VS4121 Guia Del Usuario página 6

Ocultar thumbs Ver también para VS4121:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Symptom
Possible Problem
No sound from
Bass volume is set too low. Sound source has little
subwoofer.
low-frequency content.
Radio
Too close to a radio tower.
interference.
Low hum from
The AC in your house is at 60 cycles per second, which
subwoofer.
is within the audio frequency of your subwoofer.
Loud hum from
Bad connection.
subwoofer.
Volume on your audio source set too high.
Not enough bass
Check the volume on audio source.
from subwoofer.
Bad connection.
Bass setting is too low.
Too much bass
Bass setting is too high.
from subwoofer.
Distorted
Subwoofer too close to monitor.
monitor.
Solution
Adjust the bass level on the front of the right satellite. Many .WAV and .MID
files often have little low-frequency content and sound flat when you listen
to them on a computer. Try a song with more bass—something from your
CD collection.
Move your speakers to see if the interference goes away. If not, you may be
able to purchase a shielded stereo cable from your local electronics store.
Some low hum may be detected when your speaker system is powered on
without an audio source playing, or when the volume is set at an extremely
low level.
Unplug the power cord from the surge protector (if used), and plug directly
into an AC wall outlet.
Move your cables. Check to ensure they are making a clear connection.
Lower the volume or bass level on your computer, portable audio device, etc.
Increase the volume on the audio source.
Check to make sure all cables are connected properly and are making a
clear connection.
Increase bass level on front of right satellite.
Decrease the bass level on front of the right satellite.
Because the subwoofer is not magnetically shielded, it can cause distortion if
it's too close to your monitor. Move the subwoofer so it's at least 2 feet from
your monitor.
4
Tabla de contenido
loading

Tabla de contenido