Polarized Plug - Evolution R355CPS Instrucciones Originales

www.evolutionpowertools.com

POLARIZED PLUG

WARNING (USA ONLY): To reduce the risk of electric
shock, this equipment has a polarized plug (one blade
is wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not
change the plug in any way.
VIBRATION
(1.6)
Note: The vibration measurement was made under
standard conditions in accordance with:
EN 62841-1: 2015 & EN 62841-3-10:2015.
• The declared vibration total value(s) and the
declared noise emission value(s) have been
measured in accordance with a standard test
method and may be used for comparing one tool
with another;
• The declared vibration total value(s) and the
declared noise emission value(s) may also be used
in a preliminary assessment of exposure.
WARNING:
• that the vibration and noise emissions during
actual use of the power tool can differ from the
declared values depending on the ways in which
the tool is used especially what kind of workpiece
is processed; and
• of the need to identify safety measures to protect
the operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
WARNING: When using this machine the
(1.7)
operator can be exposed to high levels of vibration
transmitted to the hand and arm. It is possible that
the operator could develop "Vibration white finger
disease" (Raynaud syndrome). This condition can
reduce the sensitivity of the hand to temperature
as well as producing general numbness. Prolonged
or regular users of this machine should monitor the
condition of their hands and fingers closely. If any
of the symptoms become evident, seek immediate
medical advice.
• The measurement and assessment of human
exposure to hand-transmitted vibration in the
workplace is given in: BS EN ISO 5349-1:2001 and
BS EN ISO 5349-2:2002.
• Many factors can influence the actual vibration
level during operation e.g. the work surfaces
condition and orientation and the type and
condition of the machine being used. Before
each use, such factors should be assessed, and
where possible appropriate working practices
adopted.
LABELS & SYMBOLS
(1.8)
WARNING: Do not operate this machine
if warning and/or instruction labels are missing
or damaged. Contact Evolution Power Tools for
replacement labels.
Note: All or some of the following symbols may
appear in the manual or on the product.
(1.9)
Symbol Description
V
Volts
A
Amperes
Hz
Hertz
Min / RPM
-1 Speed
~
Alternating Current
n o
No Load Speed
Wear Safety Goggles
Wear Ear Protection
Wear Dust Protection
Read Instructions
Wear Protective Gloves
Double Insulation Protection
CE Certification
ETL Intertek Certification
5012207
Waste electrical and
electronic equipment
Warning
(RCM) Regulatory Compliance Mark
for electrical and electronic equipment.
Australian/New Zealand Standard
5
EN