Marq ONSET 120 WW Guia Del Usuario página 4

Features
Rear Panel
1. Power In: Use a standard power cable (included) to connect this input to a power outlet.
2. Fuse: This compartment holds the fuse. Before cleaning or replacing the fuse, disconnect
Onset 120WW from its power source. Use a screwdriver or other tool to remove the
compartment (do not pull it out by the tab only). Replace the fuse only with a new fuse with the
same rating (250 V, 3 A).
3. Power Out: Use a standard power cable to connect this output to an additional fixture. This
connection will supply power to the additional fixture when this one is connected a power outlet.
Please see Setup > Linking > Power
Note: On models sold in the USA, this will be a standard "Edison" (NEMA) connection. On other
models, this will be a standard IEC connection.
4. DMX In: Use a standard 3-pin XLR cable to connect this input (A) to your DMX controller or (B) to
another fixture that will pass DMX data through it to this one. Onset 120WW receives DMX data over
this connection. Please see
5. DMX Out: Use a standard 3-pin XLR cable to connect this output to an additional fixture. Onset
120WW sends its data to an additional fixture over this connection. Please see
> DMX for information about linking multiple fixtures.
6. Display: This display shows messages and values indicating the fixture's current status.
7. Menu: Press this button to access Onset 120WW's menu.
8. Up: Press this button to select the next-highest menu option or to increase the value by 1.
9. Down: Press this button to select the next-lowest menu option or to decrease the value by 1.
10. Enter: Press this to confirm your current selection or value.
4
6
7 8 9
2
1
5
for information about linking multiple fixtures.
Setup > Linking > DMX
10
4 3
for information about linking multiple fixtures.
Setup > Linking