Craftsman 917.28858 Manual Del Operador página 27

TO LEVEL MOWER
Make sure tires are properly inflated to the
PSI shown ontires. Iftires are over or under
inflated, it may affect the appearance of your
lawn and lead you to think the mower is not
adjusted properly.
VISUAL SfDE-TO-SIDE ADJUSTM ENT
1, With all tires properly inflated and if your
lawn appears unevenly cut, determine
which side of mower is cutting lower.
NOTE: As desired, you can raise the low
side of mower or lower the high side.
2. Go to side of mower you wish to adjust.
3. With a 3/4" or adjustable wrench, turn
lift link adjustment nut (A) to the ]eft to
Iower the mower, or, to the right to raise
the mower.
Turn'nut righl Turn nut left
t0:iaise mower to lower mower
NOTE: Each full turn of adjustment nut will
change mower height about 3/16".
4. Test your adjustment by mowing some
uncut grass and visually checking the
appearance. Readjust, if necessary, until
you are satisfied with the results,
PRECISION SIDE÷TO-SIDEADJUSTMENT
1. With all tires properly inflated, parktractor
on level ground or driveway.
CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap blade
with heavy cloth.
2. Raise mower to itshighest position.
3. At both sides of mower, position blade at
side and measure the distance (A) from
bottom edge of blade to the ground, The
distanceshould bethesameon bothsides.
At ' ' tLW. 1 A
4. If adjustment is necessary, see steps 2
and 3 in Visual Adjustment instructions
above.
5. Recheck measurements, adjust if neces-
sary until both sides are equal.
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-
to-side.
Toobtain the best cutting results, the mower
blades should be adjusted so the front tip is
I/8"to 1/2" lower than the rear tip when the
41_ower i s in its highest position.
CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap blade
with heavy cloth.
o Raise mower to highest position.
o Position any blade so the tip is pointing
straight forward. Measure distance (B) to
the ground atfront and reartip ofthe blade.
• If front tip of blade is not 1t8" to 1t2" lower
than the rear tip, go to the front of tractor.
• With an 11/16" or adjustable wrench,
loosen jam nut A several turns to clear
adjustment nut B.
• With a 3/4" or adjustable wrench, turn
front link adjustment nut (B) clockwise
(Itighten) to raise the front of mower, or,
counterclockwise (loosen) to lower the
front mower.
Tighten adjust nut , Loosen adjust
B to raise mower nut B t0':10wer
mower
Loosenjam nut A first
NOTE: Each full turn ofthe adjustment nut
wilt change mower height about 1,!8",
• Recheck measurements, adjust if neces-
sary until front tip of blade is 1/8" to 1/2"
lower than the rear tip.
• Hold adjustment nutin position with wrench
and tighten jam nut securely against ad-
justment nut.
27