Using The Remote Control; Installing The Battery - Whalen SF127-23AI2D Guía De Uso Y Cuidado

Operation (continued)
6
Using the main power button
Press the power button (6) to turn the fireplace/heater unit on and off. Press the power button (6) once to turn the
□
unit on. Press again to turn the unit off.
7
Using the Demo Mode
For Use in Retail Store
□
To turn Demo Mode on, press and hold the timer button (3) for 10 seconds until the front LED lights show "00". Demo
□
Mode deactivates the heater and all front control panel buttons except the flame control button. To turn Demo Mode
off, press and hold the timer button (3) for 10 seconds until the front LED lights show "L4". This fireplace is shipped
with Demo Mode turned off for normal customer usage.

Using the Remote Control

1

Installing the battery

For replacement batteries, use AAA batteries.
Press down and slide back cover off the battery compartment.
□
Insert two provided AAA batteries into the battery
□
compartment making sure that the ends of the
batteries with the negative (-) symbols are against
the springs in the battery compartment.
Replace the battery compartment cover, making
□
sure it snaps into position.
Turn the remote over and aim it towards the fireplace/heater unit.
□
Press the power button on the upper left, and see if the flames on the fireplace/heater turn on or off.
□
If nothing appears to happen, check to make sure the battery is installed correctly, and try again.
□
6
7
OPEN CLOSE