Operating Instructions; Hose Hook-Up & Inlets - TROVAC HD7515 Manual De Instrucciones

Hose Hook-up & Inlets
Before operating your central vacuum...
Please verify that your central vacuum is properly connected to the piping
system, and to a grounded electrical outlet, and that the low voltage wires
are connected to the unit (see pages 8 to 13). Then, read the complete
owner's manual and proceed with a quick verification of your unit's
installation :
• Check bag and filter to make sure they are properly installed and not
damaged.
• Check rubber seals in each vacuum inlet.
To start your central vacuum, simply insert the hose in the vacuum inlet of
your choice. Please ensure that the tab on the hose end is properly lined
up with the slot in the inlet opening (figure 8). If your hose handle has an
integrated on/off switch, simply slide the switch to the "on" position.
Do not try to open another inlet while your system is in operation, as it may
damage the inlet's rubber seal.
• While the hose is still plugged into one inlet and the system is
operational, check other inlets for leaks.
• Plug the hose alternatively into each vacuum inlet, to ensure that each
one works properly.
14
figure 8

Operating Instructions