Thermostat Location - Empire Heating Systems DV-25-2SG Manual De Instalación, Operación E Mantenimiento

INSTALLATION INSTRUCTIONS (continued)
Warning: When vinyl siding vent kit, DV-822 or 2" x 4" (51mm
x 102mm) framing is added to an existing installation (furnace
is installed) do not attempt to add sections of pipe to the flue
outlet tube or air inlet tube. An air tight seal is required for both
tubes. Refer to Parts List, page 16 to order tubes.
Millivolt wall thermostats are specially designed for use on self-
generating systems. They should never be used on line or low
voltage A.C. circuits.
Interior Wall - The thermostat can be installed on an inside
wall.
Thermostat Bracket - The thermostat can also be attached to the
unit with the provided bracket.
1. Determine which side of the unit the thermostat will be secured
to.
2. Remove the front of the thermostat.
3. Attach thermostat to the bracket using the two (2) screws
provided. See Figure 6. Replace the front of the thermostat.
Page 10

THERMOSTAT LOCATION

Figure 6
4. If installing the thermostat bracket after the unit has been installed,
drill a hole in the side of the unit as shown in Figure 7. and
attach the bracket with a screw (not provided).
If installing the thermostat bracket before the unit is installed,
use the existing screw on the back of the unit to attach the
bracket to the unit as shown in Figure 7.
USE THIS EXISTING
SCREW (ON EITHER SIDE
OF THE HEATER) TO MOUNT
BRACKET IF INSTALLING BEFORE
UNIT IS AGAINST THE WALL.
Figure 5
Figure 5a
IF BRACKET IS INSTALLED
AFTER UNIT IS IN PLACE,
DRILL HOLE INTO CASING
SIDE AND ATTACH HERE.
PARTIAL VIEW OF
LEFT REAR CORNER
Figure 7
12434-16-1011