Polygroup SFS350 Manual De Instrucciones página 13

1. First, turn the pump off and unplug the main power cord of the system.
2. Remove the Skimmer Lock Top
q
3. Loosen all the Hose Clamps
r
4. Remove the Return Fitting -
t a
5. Remove the Pump Motor Assembly
clean the pump, dry it off, and lubricate the O-rings
6. Hold the Skimmer Canister securely so that it won't fall. Then remove the Hex Screws
7
Canister. Also, clean and dry the Filter Cartridge.
7. Store all the parts together in a dry environment that remains above 32 degrees Fahrenheit at all times.
PUMP REMOVAL INSTRUCTIONS FOR TROUBLESHOOTING
IMPORTANT:
The recommended method to troubleshoot or replace the pump is to remove the entire filtration system. Please drain enough water from the
pool so that the water level is below the skimmer opening. Then remove the entire skimmer system following steps 1 - 6 above.
REMEMBER TO KEEP ALL PARTS IN A SAFE PLACE FOR REASSEMBLY LATER.
CAUTION:
If you prefer to leave the skimmer filtration system attached to the pool we recommend having two people available to follow the process below.
PLEASE NOTE: The incorrect handling method may cause damage resulting in water leakage between the canister and liner wall.
1. First, turn the pump off and unplug the main power cord of the system. (REMEMBER TO KEEP ALL PARTS IN A SAFE PLACE FOR REASSEMBLY LATER)
2. Remove the skimmer lock top, skimmer strainer basket, filter cartridge and any chlorine tablets left inside the core section of the filter cartridge.
3. Unscrew the Locking Ring (threaded style) and
a
remove the Return Fitting Diverter
(snap-on style) the Return Fitting Diverter
insert the Service Plug to block the water
l
while troubleshooting.
28
5. After removing the pump from the canister, you can save your pool
water by carefully inserting the second service plug from the top of
the canister into the center hole at the bottom of the canister.
28
PUMP DISASSEMBLY & STORAGE
Skimmer Strainer Basket
and the Filter Cartridge
9
, Remove the Return Hose and allow water to drain out.
e
and clean the parts. Lubricate the Fitting Gasket
- from the Skimmer Canister
1 5
on the pump with petroleum jelly.
w
or unsnap
p
. Then
p
20
19
7
and remove any chlorine tablets left inside the core section of the filter.
8
with petroleum jelly and reassemble all parts.
y
by removing the Pump Mounting Screws
7
, Faceplate
f
4. Caution this step takes two people. Be prepared to get wet even if you have drained
the pool to below the skimmer opening as the canister may still contain water.
One person should hold the pump skimmer canister firmly in place while the other
person removes the pump from the bottom of the canister using a screwdriver to
remove the pump mounting screws
DO NOT pull or push the canister as this may cause damage between canister and
pool liner wall.
Volute
Housing
Outlet
Motor
Pump
OWNER'S MANUAL
using a Phillips Head screwdriver. Then
6
, Weir , Faceplate Gasket
d h s
.
6
7
Volute
11
Housing
Inlet
1-5
6
FIG.2
, and lastly the
13